2. Install the mounting bracket using the rubber washer, brass washer, and both brass nuts
on back side of the installation surface. Install the included set screw (for sheet metal
installation) or 30 mm machine screw (for drywall installations).
3. Pass the hose and sensor cord through the mounting bracket, slide the spout base over the
mounting bracket and tighten the set screw to secure the spout to the mounting bracket.
ill. 9
Rubber Washer
Plywood
(not required for sheet
metal installation)
Set Screw
(Sheet metal) or
Machine Screw
(Drywall/ Hollow
Wall)
1. If the spout connecting hose is too long, cut it to the appropriate length, making sure the
end is square.
2. Push the spout connecting hose onto the outlet barb of the controller and secure it with
the hose clamp (see ill. 1). Make sure that the hose clamp is placed fully against the
controller.
Make sure there are no obstructions between the sensor and the basin, then connect
3.
the spout sensor connector to the controller. (see ill. 2)
If you haven't connected the backup battery, connect the backup battery connector
to the controller. It will take at least 5 minutes after connecting the backup
battery for the electronics to initalize. This is a normal part of startup.
ill. 1
Spout
Connecting
Hose
Hose
Clamp
WARNING: Draw the sensor cord from the bottom of the controller while installing the
controller cover to ensure that the cord is not pinched.
IMPORTANT!
The faucet will begin an automatic sensing range adjustment immediately after the
sensor connector is plugged into the controller. Do not place your hands or other
objects in front of the sensor.This process may take up to 20 seconds to complete.
If the sensor light continues to flash for more than 20
seconds, the spout direction will need to be readjusted
for proper operation. If adjustment is necessary, you
must do it within 10 minutes of the adjustment process
will end. To restart the process, unplug the sensor
connector for 10 seconds, then reconnect it (see ill. 3)
4. Double-check all connections, then reinstall the controller cover, securing it wit
screws.
INSTALLATION PROCEDURE
Brass Washer
Nuts (2)
Connect the Spout to the Controller
Clamp fush
with
controller
NOTE: If you need to remove the hose,
you must use pliers to slide the
clamp up the hose, then use a
flathead screwdriver to carefully
pry the hose from the barb.
ill. 10
Drywall Installation
1x6 or Plywood
Bracing
M5x30
Machine
Screw
and
Wall
Anchor
Mounting
Set Screw
Bracket
Drywall
ill. 2
ill. 3
6
Sheetmetal Installation
Thin Wall
(Sheet
Metal
Surface)
M5 Set
Screw
Mounting
Bracket
Set Screw
Sensor
Connector
Backup
Battery
Connector
Sensor
Sensor
Light
h
h t
e