Installing The Main Grill - Louisiana Grills LG860C Manual Del Usuario

NOTE: Air ventilation and air register vent
covers can be positioned on the front, side
or back of the support structure. Poor/lack
of air ventilation in the support structure
will result in damage to your outdoor
kitchen and appliance.
IMPORTANT: Appropriate
required to support the floor of the support
structure without compromising the air
supply ventilation and connection to power.
The support structure must be able to
support a minimum of 181.4kg / 400lbs.
• A minimum clearance of 457mm (18 inches)
from combustible constructions to the sides
of the grill, and 457mm (18 inches) from the
back of the grill to combustible constructions
must be maintained. Note illustration 1B.
IMPORTANT: If installing an exhaust fan
above the appliance, ensure the fan hood is
a minimum of 15cm / 6" wider, on each side,
than the front width of the appliance. As
your unit is designed to produce smoke, it
is better to oversize the ventilation system
to compensate.

2. INSTALLING THE MAIN GRILL

Parts Required:
Main Grill (#6)
1 x
Installation:
• Using a minimum of two people, lift the
base of the main grill on opposing sides.
IMPORTANT: The unit is heavy. Failure to use
two people could result in injury or damage
to the appliance.
• Place the main grill carefully into the
support structure. The unit should sit level
and centered in the space, unfastened to
the support structure, allowing for easy
maintenance. Allow the power cord to pass
through the air supply ventilation, ensuring
that the cord is not pinched in any way.
TIP: The smoke that exits the rear grill vents
can quickly blacken brick work and other
surfaces. Install a removable backsplash for
easy cleaning.
• Continue installation with Step 3 of the
LG860C Assembly Instructions .
1B
planning is
457mm
/ 18 in
2
MINIMUM CLEARANCE TO
COMBUSTIBLE MATERIALS
457mm
/ 18 in
457mm
/ 18 in
Air Supply
Ventilation
750mm
/ 30 in
457mm
/ 18 in
457mm
/ 18 in
Air Exhaust
Ventilation
9