M
PHONES/
LINE OUT
N
O
Use a commercially available connection cord which has a 3.5ø stereo mini lug
at one end and two phono plugs at the other end.
Connect the stereo mini-plug to the PHONES/LINE OUT jack of the unit and connect
the phono plugs to the analog input terminals of the external unit.
Note
• Turn off the power of both units before connection.
• DO NOT connect to the PHONO inputs of an amplifier (with a built-in
phonoequalizer-amplifier).
• Adjust the volume and DSL on this unit.
MAINTENANCE
To clean the lens → N
If the lens becomes dirty, the player will skip or not play. If this occurs, clean the
lens in the following manner.
To remove dust or dry particles, first use a camera lens blower/brush a to blow a
few times to loosen particles, then gently brush the lens b clean. Finish by blowing
the lens again.
To remove fingerprints, use a cotton swab dipped in lens cleaning solution. Wipe
gently from the center to the edge. Lens cleaning solution is commercially available.
Note
Take care not to get too much solution on the swab, which could flow into the unit
and cause damage.
Pressing too strongly with the swab could scratch or break the lens.
To clean the discs → O
Before playing, wipe the disc from the center outward with a cleaning cloth. After
playing, store the disc in its case.
SPECIFICATIONS
Tracking system
3-beam laser
Laser pickup
Semiconductor laser
D/A conversion
4-times oversampling digital filter + 1-bit DAC
Frequency response
20 – 20,000 Hz (47 k ohms)
Output
PHONES/LINE OUT jack (stereo mini-jack)
Maximum output
12 mW + 12 mW (16 ohms at 1 kHz)
500 mV (47 k ohms at 1 kHz)
Power supply
DC 3 V using two size AA (LR6) alkaline batteries
DC 2.4 V using commercially available
rechargeable batteries
AC house current using the supplied AC adaptor
Maximum outside dimensions
132 (W) × 30 (H) × 141 (D) mm (excluding
projecting parts and controls)
(5
1
/
4
Weight
Approx. 270 g (9.5 oz.) excluding batteries
Accessories
AC adaptor AC-D603 (1)
Stereo headphones (1)
Carrying case (XP-SP911 only) (1)
AC adaptor AC-D603
Rated input: AC 120 V, 60 Hz
The specifications and external appearance of this unit are subject to change
without notice.
× 1
× 5
3
/
5
/
in.)
16
8