Assembly Instructions - Kobalt SGY-AIR138TZ Manual Del Usuario

ASSEMBLY INSTRUCTIONS

1. Remove the air inlet protective cap from the
air inlet (J) (See Figure 1).
2. NOTE Use threaded sealant tape (not included)
on the threading of the male plug. Once sealant
tape is properly in place, tighten male plug turning
clockwise with a wrench (not included) for air tight
connection. DO NOT OVERTIGHTEN.
3. Mount a male plug (not included) by hand into
the air inlet (J) (See Figure 2).
4. Place 2 - 3 drops of air tool oil (not included)
into the male plug before each use
(See Figure 3).
NOTE This machine's gears should be lubricated
every working day of use. This tool has a
flush-type grease fitting (G) (See Figure 3).
Please consult your local retailer for assistance on
which type of grease gun to use with this type of
fitting.
1
2
3
10
J
J