Connecting Cables - Epson TM-L90 Manual Del Usuario

English
Width note:
When you want to set the roll
paper width from 61 mm to
70 mm, break off by hand the
two tabs of the spacer shown in
the illustration. (You can still
also use widths from 38 mm to
60 mm with the spacer with the
tabs broken off.)
4. Insert the screw included
with the spacer into the hole
indicated below and tighten it. (Even if you can see two holes, this
is the only one to put the screw in.)

Connecting Cables

To connect cables, first remove the bottom
of the cover as shown in the illustration.
To place cables, first break off by hand any
of the three portions indicated by circles in
the illustration (the other portion is on the
right). Then put the cables through the
holes and replace the bottom of the cover.
8 TM-L90 User's Manual
tabs
hole for screw