Starting Operation - ProMinent DULCO Trans 50/1200 PVDF Instrucciones De Servicio

Safety instructions hand nozzle, Starting operation
 Regularly check the hose clamp for tight fit.
 Check outlet tube and seal for tight fit. If necessary,
tighten again outlet tube and/or replace seal.
 When using a hand nozzle with an attached key button,
only use the key button with a safety extra-low voltage.
Generally replace a defect signalling cable.
 Only use the hand nozzle with safety handle.
 Non-compliance with the safety instructions may cause
injuries to the operator, pollution of the environment or
damage to the hand nozzle.

Starting operation

 Ensure that the supply voltage corresponds with
the voltage indicated on the name plate.
 Never operate the pump unless the union nut between
motor and pump has been firmly tightened.
 Immerse the pump vertically into the liquid and secure it in a
vertical position by the use of a barrel fitting or a screw clamp.
 Always check power supply cable for damage
before starting operation.
 Keep solvents away from the power supply cable.
 Only switch the motor on when the pump is in the liquid.
 Before inserting the plug to the socket, ensure that
on/off-switch is set to "0" (Stop).
 Insert the plug.
 Switch on the motor.
15