Jata calor C204NT Instrucciones De Uso página 13

• If the cable were to deteriorate it must be changed by an
Authorised Service Centre.
LEGS ASSEMBLING
• The legs (7) must be assembled at the ends of the lower part of the appliance.
• Make coincide the holes of the legs with the corresponding holes of the appliance and screw them by using the
screws of shortest length included.
WALL ASSEMBLING
• attention: the minimum distances for wall mounting:
- From the floor: 10 cm.
- From the lateral walls: 20 cm.
• In any case above the radiator there should be no impediment (tables, shelves, etc.).
• To fix the appliance to the wall:
- place the upper support (10) against the wall and mark the holes. The distance between the holes must be
390 mm. (Fig. a).
- perforate the wall on the marked holes and insert the wads.
- Next fix the supports to the wall with the two largest screws.
- Before placing the convector on the wall, enter the last stand in the bottom window of the back of the unit
(Fig. B). The support must be fixed later.
- place the radiator tilting it slowly and making coincide the supports (10) with the windows placed in the back
side of the appliance and press it down slowly to leave it correctly fixed.
- after the appliance is fixed correctly, mark again in the wall the hole corresponding to the lower support.
- Remove the appliance from the wall, make the hole on the marked point and insert the wad.
- To finish, place again the appliance onto the support and screw it with the lower support to the wall.
INSTRUCTIONS OF USE
OPERATION WITHOUT PROGRAMMER
• The function selector (9) of the programmer must be set to "I" position.
• Connect the device to the network.
• Turn the thermostat control knob (1) in the clockwise sense to its maximum position (MaX).
• Determine the level of power you want by turning the power switch (2) clockwise and taking into account:
position I: Minimum power
position II. : Max power
position I ( ): Minimum power with fan (turbo function)
position II ( ): Maximum power with fan (turbo function)
position 0: off.
When making this operation the leD (3) lights up.
In the positions with turbo fan function, air, besides being delivered by convection top rack will be expelled
forcibly from the side grid of the device (5).
• When the room temperature is the desired one, turn the thermostat controller (1) counter clockwise until the
indicator light turns off indicating that the thermostat is disconnected.
• let it in that position, as the thermostat is responsible for automatically maintain the set temperature, starting
cycles off and on, with saving energy.
• When not using the heater, turn the power selector (2) to "0", the thermostat knob to off position (MIN) and
disconnect the device from the mains.
PROGRAMMER OPERATION
• The convector is equipped with a practical programmer that allows the device to be connected and disconnected
at times that have been previously selected.
• place the function selector (9) in position
• Turn in the direction of the arrow to set the timer at the current time, by matching the time with the indicatio
01 JATA manual C204NT.indd 13
.
13
.
09/06/16 16:08