EN-4
3.3 Using the Balance
Weighing Application
1.
If required, place an empty container on the pan and press Tare.
2.
Add sample to the pan or container. The display shows the weight of the sample.
4. MAINTENANCE
4.1 Calibration
When the Balance is first installed, and when it is moved to another location, it must be calibrated to ensure accurate
weighing results.
4.2 Cleaning
WARNING: Electric Shock Hazard. Disconnect the equipment from the power supply before cleaning.
Make sure that no liquid enters the interior of the instrument.
Attention: Do not use solvents, harsh chemicals, ammonia or abrasive cleaning agents.
The exterior surfaces of the instrument may be cleaned with a cloth dampened with water and a mild detergent.
4.3 Troubleshooting
For technical issues contact an Authorized Ohaus Service Agent. Please visit our website www.ohaus.com to locate the
Ohaus office nearest you.
5. TECHNICAL DATA
The technical data is valid under the following conditions:
Indoor use only
Altitude: Up to 2000 m
Operating temperature range: +5 °C to +40 °C
Specified temperature range: +10 °C to +40 °C
Relative humidity: 10% to 80% at 31°C, decreasing linearly to 50% at 40°C, non-condensing
Mains supply voltage fluctuations: up to ±10% of the nominal voltage
Installation category II
Pollution degree: 2
SPECIFICATIONS:
MODEL
Capacity
Readability d
Repeatability (std. dev.)
Linearity
Power
MODEL
Capacity
Readability d
Repeatability (std. dev.)
Linearity (g)
Power
6. COMPLIANCE
Compliance to the following standards is indicated by the corresponding mark on the product.
Mark
Standard
This product complies with the EU Directives 2014/30/EU (EMC), 2014/35/EU (LVD) and 2014/31/EU
(NAWI). The EU Declaration of Conformity is available online at www.ohaus.com/ce.
This product complies with the EU Directive 2002/96/EC (WEEE). Please dispose of this product in
accordance with local regulations at the collecting point specified for electrical and electronic equipment.
For disposal instructions in Europe, refer to www.ohaus.com/weee.
AS/NZS 61000.6.1, AS/NZS 61000.6.3
STX123
STX223
120 g
220 g
0.001 g
0.001 g
2 d
2 d
3 d
3 d
AC power adaptor input 100-240 V 50/60 Hz and output 5V/1A DC, or 4 AA batteries
STX2202
STX421
2200 g
420 g
0.01 g
0.1 g
2 d
1 d
3 d
1 d
AC power adaptor input 100-240 V 50/60 Hz and output 5 V/1A DC, or 4 AA batteries
STX222
STX422
220 g
420 g
0.01 g
0.01 g
1 d
1 d
1 d
1 d
STX621
STX2201
620 g
2200 g
0.1 g
0.1 g
1 d
1 d
1 d
1 d
STX BALANCES
STX622
STX1202
620 g
1000 g
0.01 g
0.01 g
1 d
2 d
2 d
3 d
STX6201
STX8200
6200 g
8200 g
0.1 g
1 g
1 d
1 d
2 d
1 d