EAS ELECTRIC EMD09X2-V1 Manual De Instrucciones página 59

Please follow the steps below for adding dishwasher salt:
1. Remove the lower basket and unscrew the reservoir cap.
2. Place the end of the funnel (supplied) into the hole and pour in
about 1.5kg of dishwasher salt.
3. Fill the salt container to its maximum limit with water. It is
normal for a small amount of water to come out of the salt
container.
4. After filling the container, screw back the cap tightly.
5. The salt warning light will stop being after the salt container
has been filled with salt.
6. Immediately after filling the salt into the salt container, a
washing program should be started (We suggest to use a short
program). Otherwise the filter system, pump or other important
parts of the machine may be damaged by salty water. This is out
of warranty.
NOTE
The salt container must only be refilled when the salt warning
light ( ) in the control panel comes on. Depending on how well
the salt dissolves, the salt warning light may still be on even
though the salt container is filled.
If there is no salt warning light in the control panel (for some
Models), you can estimate when to fill the salt into the softener
by the cycles that the dishwasher has run.
If salt has spilled, run a soak or quick program to remove it.
10 V.2