EAS ELECTRIC EMD09X2-V1 Manual De Instrucciones página 72

Full-integrated model
Install the hook on the aesthetic wooden panel and put the hook into the
slot of the outer door of dishwasher (see figure A). After positioning of the
panel , fix the panel onto the outer door by screws and bolts (See figure B).
A
Step 3. Tension adjustment of the door spring
1. The door springs are set at the
factory to the proper tension for the
outer door. If aesthetic wooden
panel are installed, you will have to
adjust the
Rotate the adjusting screw to drive
the adjustor to strain or relax the
steel cable.
2. Door spring tension is correct when
the door remains horizontal in the
fully opened position, yet rises to a
close with the slight lift of a finger.
B
door spring tension.
1.Take away the four short screws
2.Pin up the four long screws
23 V.2