EAS ELECTRIC EMD09X2-V1 Manual De Instrucciones página 90

Filling The Rinse Aid Reservoir
Remove the rinse reservoir
1
cap by lifting up the handle .
3
Close the cap after all.
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the
dishwasher is designed to adjust the consumption by user. Follow the
below steps.
1. Close the door, switch on the appliance.
2. Within 60 seconds after step 1, press the Program button more
than 5 seconds, and then press the Half-Load button to enter the
set model, the rinse aid indication blinks as 1Hz frequency.
3. Press the Program button to select the proper set according to
your using habits , the sets will change in the following sequence:
D1->D2->D3->D4->D5->D1. The higher the number, the more rinse
aid the dishwasher uses. The factory setting is D3.
4. Without operation in 5 seconds or press the power button to exit
the set model, the set success.
Selector position
D1-> rapid Light bright
D2-> 90min Light bright
D3-> 90min, rapid Light bright
D4-> ECO Light bright
D5-> ECO, rapid Light bright
Pour the rinse aid into the
2
dispenser, being careful
not to overfill.
Amount of rinse aid (mL)
41
1.2
2.4
3.6
4.8
6.0
V.2