STOK QUATTRO SGP4032N Manual Del Usuario página 14

STEP 8: INSTALLING THE WARMING RACK
See Figure 13.
 Fully raise the hood.
 Lay the warming rack in the grooves on each side of the
hood and lock it into the rear pilot holes as shown.
WARMING
RACK
Fig. 13
STEP 9: INSTALLING SIDE SHELVES
See Figures 14 - 15.
To install the utility bar onto the side shelf:
 Line up holes in right utility bar (Z) and trim washers (A1)
with holes on the right side shelf (D).
 Insert bolt (HH) and washer (KK) through the hole in the
shelf, through the trim washer and into the end of the bar.
 On the right side shelf only, place the match stick chain
and washer between the bolt and shelf.
 Repeat steps for other side.
To install the side shelf:
 Loosen the screws from the spacers on each side of the
firebox.
 Slide the keyhole slots in the side shelf over the screws.
 Securely tighten the screws.
ASSEMBLY
PILOT
HOLE
GROOVES
Fig. 14
Fig. 15
14
RIGHT UTILITY
BAR (Z) BRACKET
MATCH STICK CHAIN
BOLT (HH)
LEFT
SIDE
SHELF
(A)
KEY HOLES
SCREW
SPACER
LEFT SIDE
SHELF (A)
TRIM WASHER
(A1)
WASHER (KK)
BOLT (HH)
AND WASHER (KK)
(RIGHT SIDE ONLY)
RIGHT SIDE SHELF (D)