Signal Led - Renishaw RLP40 Manual Del Usuario

Note: Unless the RLP40 is in
"Multiple probe" mode, it will be
necessary to partner it with the RMI
before use.
Note: In configuration mode,
configure the settings as required
and then enter the "Acquisition
mode" menu. Select "Acquisition
mode off".
Note: Once in "Acquisition mode
off" ensure the next two steps are
completed within 20 seconds.
1-12
RLP40 – RMI partnership
Acquisition
mode
off
Switch on the RMI
3
< 4 s
continued on next page
Acquisition mode
Acquisition
mode
on

SIGNAL LED

RMI in acquisition mode
Deflect the stylus to select
"Acquisition mode on".
Ensure this is done within
10 seconds of the RMI
signal LED flashing green.
3