Troubleshooting Guide; Blower And Battery - Stihl BGA 57 Manual De Instrucciones

Ocultar thumbs Ver también para BGA 57:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English

23 Troubleshooting Guide

23.1 Blower and Battery

Always remove the battery before carrying out any inspection, cleaning or maintenance.
Condition
LEDs on
Battery
Blower does not start
when switched on.
1 LED flashes
green.
1 LED glows
red.
4 LEDs flash
red.
3 LEDs glow
red.
3 LEDs flash
red.
Blower cuts out
1 LED glows
during operation.
red.
3 LEDs glow
red.
26
Cause
Remedy
No electrical contact
► Remove the battery, @ 14.2.
between blower and
► Visually check the electrical contacts in the battery
battery.
compartment and on the battery.
► Reinsert the battery, @ 14.1.
Battery has low
► Charge the battery, @ 11.
charge.
Battery too hot / too
► Allow the battery to warm up or cool down gradually at
cold.
ambient temperatures of about 50 °F to 68 °F (10 °C to
20 °C).
Malfunction in
► Remove the batter and reinsert it, @ 14.
battery.
► Switch on the blower, @ 15.1.
► If the LEDs continue to flash, do not attempt to use.
The battery has a malfunction and must be replaced.
Blower too hot.
► Allow the blower to cool down.
Malfunction in
► Remove the battery and reinsert it, @ 14
blower.
► Switch on the blower, @ 15.1.
► If the LEDs still flash, do not attempt to use.
The blower has a malfunction and must be checked by a
servicing dealer.
Battery too hot / too
► Remove the battery, @ 14.2.
cold.
► Allow the blower and battery to cool down gradually at
Blower too hot.
ambient temperatures of about 50 °F to 68 °F (10 °C to
20 °C).
23 Troubleshooting Guide
0458-807-8621-A

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido