use an extension cord, the extension cord should be rated for
13 amps, 125V, 1625 watts.
− The power supply cord must be arranged so that it will not
drape over the countertop or tabletop where it can be pulled
on by children or tripped over accidentally.
Operation
1. Lift water tank (p. 3, fig. A
hands.
2. NOTE: DO NOT hold water tank by handle when empty or full.
3. Turn tank upside down and unscrew water tank cap (p. 3, fig. A
counterclockwise.
4. Fill water tank with cold water. Do not fill all the way to the rim.
5. NOTE: If you have hard water, it is recommended to use filtered or distilled water.
While using the humidifier, if you see a film of white dust, it is because of hard
water.
6. DO NOT add any medication or other additives into the water tank itself. For use of
essential oils, see page 17.
7. Screw water tank cap (p. 4, fig. E
8. Place tank onto the base (p. 4, fig. F
There should not be a space between the tank and base.
9. Place mist lid on top of water tank.
10. NOTE: DO NOT move humidifier while water tank is on base. Water may leak into
the base causing a malfunction.
11. Plug the power cord into an electrical outlet. DO NOT use an extension cord.
12. Turn power on by turning the control knob (p. 3, fig. A
right). You will hear a minor clicking noise when turning unit on and off. The
green power indicator light (p. 3, fig. A
9
) off of base holding bottom of tank with both
10
) back onto tank by turning clockwise.
2
). Make sure it is laying flush into the base.
7
) will turn on.
10
) by turning it
6
) clockwise (to the
Operation
15