FCC PART 15
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may cause harmful interference, and (2) this device must
accept any interference received, including interferences that may cause undesired
operation.
Warning: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class
B ISM equipment, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experience radio/TV technician for help.
Safety
Explanation of instructions
The following symbols and signal words are used in these instructions.
WARNING!
CAUTION!
NOTICE!
This signal symbol/word refers to a hazard with a
medium level of risk that, if not avoided, may result
in death or serious injury.
This signal symbol/word refers to a hazard with a
low level of risk that, if not avoided, may result in
minor or moderate injury.
This signal word warns of possible material
damage.
Safety
7