Hama 179810 Instrucciones De Uso página 17

Note
• At default setting mode, the Volume lock function is deactivated.
6.3 Macro Power
Macro Power enables you to turn two A/V devices on/off simultaneously.
6.3.1 To activate the macro power setting:
• Press and hold [MUTE] and [Vol+] keys for 3 seconds until the LED remains on.
• Select the desired device key ( e.g. [TV] ), a successful selection is indicated by
the LED with one flash followed by permanent light.
• Enter the code [9] [5] [0], the LED will flash two times and then remain on.
• Select another desired device key ( e.g. [STB] ), a successful selection is
indicated by the LED with one flash followed by permanent light.
• Press and release [OK], if the LED flashes three times and then turns off it
means that the setting is activated.
6.3.2 To deactivate the macro power setting:
• Press and hold [MUTE] and [Vol+] keys for 3 seconds until the LED remains on.
• Select the desired device key ( e.g. [STB] ), a successful selection is indicated by
the LED with one flash followed by permanent light.
• Enter the code [9] [5] [0], the LED will flash two times and then remain on.
• Select another desired device key ( e.g. [TV] ), a successful selection is indicated
by the LED with one flash followed by permanent light.
• Press and release [EXIT], if the LED flashes three times and then turns off it
means that the setting is deactivated.
Note
• f you entered an incorrect code, the LED will blink 3 times and then remain
on, you can directly re-enter the correct code.
• No entry for approx. 30 seconds will time out the Setup mode. The LED
indicator shows three flashes and turns off.
7. LEARN MODE
This remote control is equipped with a learning function. Thus, you could learn
functions of your original remote to this remote control.
7.1 BEFORE STARTING LEARN MODE
7.1.1 The batteries in the two remote controls have to be in good condition.
Replace them if necessary.
7.1.2 Place the remote controls with the infrared diodes so that they point
towards each other.
7.1.3 Where necessary adjust the height of both remotes so that infrared diodes
are properly aligned.
7.1.4 The distance between the remote controls should be about 3 cm.
ROC1117GRU 6in1
16
ORIGINAL
ca. 3 cm