Direct Code Entry; Manual Code Search - Hama 179810 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 30

5.1 Direct Code Entry

Your Universal Remote Control Package contains a code list. The code list shows
4-digit codes for most A/V device manufacturers in alphabetical order and
grouped by device type (e.g. TV, DVD, etc.). If the device you want to control
is covered by the code list, the Direct Code Entry is the most convenient entry
method.
5.1.1 Turn on the device you want to control
5.1.2 Press the [SETUP] key until the LED indicator is permanently lit.
5.1.3 Select the device you want to control using the device key (e.g. [TV]). A
successful selection is indicated by the LED with one flash followed by
permanent light.
5.1.4 Check code list for brand and type of the device you want to control.
5.1.5 Enter the corresponding 4-digit code using the [0 – 9] keys. The LED
indicator confirms each entered digit via a short flash and turns off after
the fourth digit.
Note
• If the code is valid, it is saved automatically.
• If the code is invalid, the LED indicator flashes three times and then is
permanently lit. You can re-enter the code again.
• If no device is selected, it will consider current device as default.

5.2 Manual code search

Your Universal Remote Control is equipped with an internal memory, which
is preloaded with up to 350 codes per device type for the most common A/V
devices. You can zap through these codes until the device you want to control
shows a reaction. This might be that the device you want to control switches off
( [POWER] key ) or changes the channel ( [Ch+/Ch-] keys ).
5.2.1 Turn on the device you want to control
5.2.2 Press the [SETUP] key until the LED indicator is permanently lit.
5.2.3 Select the device you want to control using the device key (e.g. [TV]). A
successful selection is indicated by the LED with one flash followed by
permanent light.
5.2.4 Press the [POWER] or the [Ch+/Ch-] key to zap through the preloaded
codes until the device you want to control reacts.
5.2.5 Press [SETUP] key to save the code and exit the code search. The LED
indicator turns off.
Note
• Press [EXIT] key to exit the setup mode directly without code saving, the
LED indicator flashes three times and then turns off.
• If no device is selected, it will consider current device as a default.
• Internal memory limitations allow only up to 350 most common device
codes to be preloaded. Due to the extensive number of different
available A/V devices on the market, it may be possible that only the most
common main functions are available. If so, repeat steps 5.2.1 to 5.2.5 to
find a more compatible code. No code may be available for some special
device models.
13

Publicidad

Tabla de contenido
loading

Tabla de contenido