Default Setting - Hama 179810 Instrucciones De Uso

Note
While replacing the batteries, the remote control will keep the functions of
the learned keys.
7.4 CLEARING OF LEARNED KEYS
7.4.1 CLEARING OF ONE LEARNED KEY
• Press and hold [MUTE] and [Vol+] keys for 3 seconds until the LED will be lit.
• Select the device you want to clear a learned command using the device
key ( e.g. [TV] ). A successful selection is indicated by the LED with one flash
followed by permanent light.
• Enter the code [9] [8] [1], the LED will flash 2 times and then remain on.
• Press and release the desired key at the Universal Remote control which you
want to clear the learned command. If the LED flashes four times, the learned
command has been cleared successfully.
7.4.2 CLEARING OF ALL LEARNED KEYS
• Press and hold [MUTE] and [Vol+] keys for 3 seconds until the LED will be lit.
• Select the device you want to control using the device key ( e.g. [TV] ). A
successful selection is indicated by the LED with one flash followed by
permanent light.
• Enter the code [9] [8] [2], the LED will flash 2 times and then remain on.
• Press and release the [SETUP] key at the universal remote control. If the LED
flashes four times, all commands have been cleared successfully.

8. Default setting

8.1 Press and hold [SETUP] key for 3sec until the LED remains on.
8.2 Press and release the [MUTE] key, the LED will flash one time and then
remain on.
8.3 Press and release the numeric [0] key, if the LED flashes four times and
then turns off it means you have gone back to default setting successfully.
Note
All device settings and learned commands will be cleared if the remote is set
back to default settings.
9. Maintenance
• Do not mix new and used batteries for powering the Universal Remote
Control, as old batteries tend to leak and may cause power drain.
• Do not use corrosive or abrasive cleaners on your Universal Remote Control.
• Keep the Universal Remote Control dust free by wiping it with a soft, dry
cloth.
18