Use Of The Digital Touch Timer - Svan SVH224X1 Manual De Usuario

operating. This function is used for faster
grilling and for grilling food with a larger
surface area, such as meat. Use the upper
shelves of the oven. Lightly brush the wire
grid with oil to stop food sticking and place
food in the centre of the grid. Always place
a tray beneath the food to catch any drips
of oil or fat. It is recommended that you
preheat the oven for about 10 minutes.
Warning: When grilling, the oven door
must be closed and the oven
temperature should be adjusted to
190°C.
start operating. This function is used for
faster grilling of thicker food and for grilling
food with a larger surface area. Both the
upper heating elements and grill will be
energised along with the fan to ensure even
cooking. Use the upper shelves of the oven.
Lightly brush the wire grid with oil to stop
food sticking and place food in the centre of
the grid. Always place a tray beneath the
food to catch any drips of oil or fat. It is
recommended that you preheat the oven for
about 10 minutes.
Warning: When grilling, the oven door
must be closed and the oven
temperature should be adjusted to
190°C.
Vap Clean Function: Set the oven
function and thermostat to the Vap
Clean function symbol. Pour
200-250ml of water (about 1 cup)
into the small tray on the oven base. Vap
Clean runs for approximately 20 minutes
and will prepare your oven so that it can be
easily cleaned.
Double Grill and Fan
Function: The oven's
thermostat and
warning lights will
switch on, and the grill,
upper heating
elements and fan will

Use of the Digital Touch Timer

Time adjustment
The time must be set before you start using
the oven. Following the power connection,
the symbol "A" and "00:00" or "12:00" will
flash on the display.
EN - 15
Function Description
Auto cooking
Manual cooking
Key Lock
Minute minder
Mode function
Decrease timer
Increase timer
Timer display
1. Press the "MODE"
for 2 sec to deactive
keylock and the dot
in the middle of the
screen will start to
flash.
2. Adjust the time while
the dot is flashing
using the "+" and "-"
keys.