Light Bulbs (Ten1 Series Only); Install The Filter(S) - Broan Elite TEN1 Serie Manual De Instalación, Uso Y Cuidado

Light Bulbs
The TEN1 Series range hoods require two shielded Halogen Bulbs (120 V, 50 W max., MR16 or
PAR16 with GU10 base) (not included).
1 ] Align the bulb leads with the small indentations located on the border of the lamp location on
2 ] Gently push upwards and turn clockwise until secure.
NOTE: The Suction Cup Tool (included with hood) can be used to install and remove light bulbs.

Install the Filter(s)

Ducted Installation Only:
Re-install grease filter(s) removed in step 2 on page 9 under "Prepare the Hood" .
Non-ducted Installation Only:
Purchase 1 or 2 non-ducted filters from your local distributor or retailer (see product specification
label inside of hood for filter type and part number). Attach the non-ducted filter(s) following
instructions packed with the non-ducted filter(s).
20
(TEN1 Series only)
Do not touch lamps during or soon after operation. Burns may occur. In order to prevent
the risk of personal injury, only install shielded halogen lamps. Also, never install a cool
beam, a dichroic lamp, a lamp not suitable for use in recessed luminaires or identified for
use in enclosed fixtures.
BULB LEADS
hood (see inset above), then install the bulbs by placing the bulb leads into their grooves in
the socket.
Press suction cup tool on bulb and rotate counterclockwise to remove bulb or clockwise to
install bulb.
Most GU10 LED replacement bulbs commonly found in the market are not designed
for use in a cooking environment and might not perform as advertised. Their usage
with this product is not recommended.
!
WARNING
BULB LEAD
GROOVES
(IN SOCKET)
! CAUTION
SUCTION
CUP TOOL