Kohler Sterling 7204 Serie Guia De Instalacion página 10

7. Apply Silicone Sealant
IMPORTANT! Use a clear 100% silicone sealant. Latex, caulk, or siliconized latex sealants may not provide
water and mildew resistance over the life of the product.
IMPORTANT! Do not allow the sealant to set before the end walls are installed. After applying sealant,
immediately proceed to the "Install the Wall Surrounds" section of this guide.
NOTE: Sealant will compensate for out-of-plumb walls and exposure to water at the flange area. The
sealant will be hidden when the wall surrounds are installed, and will eliminate future maintenance.
Clean and dry the outer few inches of the receptor flange at the point where the end walls will be
installed.
Apply an L-shaped bead of clear 100% silicone sealant at each outer end of the flange where the
end walls will be installed. Apply the bead so it is a minimum of of 1/4" (6 mm) wide and 1" (2.5
cm) by 4" (10.2 cm) long, as shown in the illustration.
1022034-2-D
4" (10.2 cm)
1"
(2.5 cm)
1/4" (6 mm)
Apply clear 100%
silicone sealant
before installing
walls.
10 Sterling