Kohler Sterling 7204 Serie Guia De Instalacion página 9

Drill Pilot Holes
6. Cut the Valve Holes
IMPORTANT! Risk of product damage. Determine whether your saw blade cuts on the pull or push
stroke. Failure to follow directions regarding your blade's cutting direction may damage the end wall's
finish.
If you are using a saw blade that cuts on the pull stroke, remove the end wall. Mark locations for
the valve and shower controls on the unfinished side (back side) of the end wall.
If you are using a saw blade that cuts on the push stroke, mark locations for the valve and shower
controls on the finished side (front side) of the end wall. When completed, remove the end wall.
Drill 1/4" (6 mm) pilot holes at the marked locations.
Carefully drill the fitting holes with a saw of the correct diameter.
Sterling 9
Cut the Holes
1022034-2-D