After Installation - LUCCI Air NAUTILUS Instrucciones De Instalación

Nautilus Fan Installation Instructions
REVERSING SWITCH
• Your ceiling fan can operate in either summer or winter mode.
• Loosen the set screw (1) and lift up the cover to access the reverse switch (2).
SUMMER Mode: The reverse switch shall be in the SUMMER position to make the fan rotate in an counter
clockwise direction. The airflow will be directed downwards, for cooling in summer.
WINTER Mode: The reverse switch shall be in the WINTER position to make the fan rotate in a clockwise
direction. The airflow will be directed upwards assisting in the circulation of warm air, for energy
conservation in winter.
Fig. 15

AFTER INSTALLATION

WOBBLE:
NOTE: ceiling fans tend to move during operation due to the fact that they are mounted on a rubber
grommet. If the fan was mounted rigidly to the ceiling it would cause excessive vibration. Movement of a
few centimetres is quite acceptable and DOES NOT suggest any problem.
TO REDUCE THE FAN WOBBLE: Please check that all screws which fix the mounting bracket and down
rod are secure.
BALANCING KIT: A balancing kit is provided to balance the ceiling fan on initial installation. Please refer to
the instruction on how to use the balancing kit. The balancing kit can be used to assist re-balancing should
the ceiling fan become un-balanced again. Store your balancing kit away after installation for future use if
required.
NOISE:
When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and
frequency signals superimposed in the electricity for off-peak hot water control, may cause a change in fan
motor noise. This is normal. Please allow a 24-hour "settling-in" period, most noises associated with a new
fan disappear during this time.
The manufacturer's warranty covers actual faults that may develop and NOT minor complaints such as
hearing the motor run – All electric motors are audible to some extent.
9 | P a g e
V1.0 (09/2019)