After Installation; Care & Cleaning - LUCCI Air AIRFUSION PEREGRINE Manual De Instalación

AIRFUSION PEREGRINE Installation Instructions
THE RECEIVER PROVIDES THE FOLLOWING LEVEL OF PROTECTION:
•
Lock position: the receiver has a built in safety feature to protect against obstruction during operation.
The motor will be locked from operation and will disconnect from power after 30 seconds of interruption.
Please remove obstacles before re-starting. To reset, simply turn off the power supply to the fan motor
and re-start.
• Over 80W protection: when the receiver detects power consumption which is greater than 80W, the
receiver power will be stopped and operation will immediately discontinue. Turn the receiver power on
after 5 seconds to restart the fan.
NOTE: Ceiling fans tend to move during operation due to the fact that they are mounted on a rubber grommet.
If the fan was mounted rigidly to the ceiling it would cause excessive vibration. Movement of a few centimetres
is quite acceptable and DOES NOT suggest any problem.
TO REDUCE THE FAN WOBBLE: Please check that all screws which fix the mounting bracket and down rod
are secure.
BALANCING KIT: A balancing kit is provided to balance the ceiling fan on initial installation. Please refer to
the instruction on how to use the balancing kit. The balancing kit can be used to assist re-balancing should
the ceiling fan become un-balanced again. Store your balancing kit away after installation for future use if
required.
NOISE:
When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and
frequency signals superimposed in the electricity for off-peak hot water control, may cause a change in fan
motor noise. This is normal. Please allow a 24-hour "settling-in" period, most noises associated with a new
fan disappear during this time.
The manufacturer's warranty covers actual faults that may develop and NOT minor complaints such as hearing
the motor run – All electric motors are audible to some extent.
NOTE: Always turn OFF the power at the mains switch before performing any maintenance
or attempting to clean your fan.
•
Every 6 months periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush
or lint free cloth to avoid scratching the paint finish. Please turn off electricity power when you do so.
•
Do not soak or immerse your ceiling fan in the water or other liquids. It could damage the motor or the
blades and create the possibility of an electrical shock.
•
Ensure that the fan does not come in contact with any organic solvents or cleaners.
•
To clean the fan blade, wipe with only a damp clean cloth with NO organic solvents or cleaners.
•
The motor has a permanently lubricated ball bearing so there is no need to oil.
14 | P a g e

AFTER INSTALLATION

CARE & CLEANING