Additional Safety Warnings - Bosch JS572E Instrucciones De Funcionamiento Y Seguridad

a. Hold the power tool by insulated
gripping surfaces, when performing an
operation where the cutting accessory
may contact hidden wiring or its own
cord. Cutting accessory contacting a "live"
wire may make exposed metal parts of
the power tool "live" and could give the
operator an electric shock.
b. Use clamps or another practical way to
secure and support the workpiece to a
stable platform. Holding the workpiece
by hand or against your body leaves it
unstable and may lead to loss of control.
c. Do not drill, fasten or break into
existing walls or other blind areas
where electrical wiring may exist. If
this situation is unavoidable, disconnect
all fuses or circuit breakers feeding this
worksite.
d. Never leave the trigger locked "ON".
Before plugging the tool in, check that
the trigger lock is "OFF". Accidental
start-ups could cause injury.
e. Be aware of the location and setting of
the switch "Lock-ON" button. If the
switch is locked "ON" during the use, be
ready for emergency situations to switch
it "OFF", by first pulling the trigger then
immediately releasing it without
pressing the "Lock-ON" button.
GFCI and personal protection devices like
electrician's rubber gloves and footwear will
further enhance your personal safety.
Do not use AC only rated tools with a DC
power supply. While the tool may appear to
work, the electrical components of the AC
rated tool are likely to fail and create a hazard
to the operator.
Keep handles dry, clean and free from oil
and grease. Slippery hands cannot safely
control the power tool.
Develop a periodic maintenance schedule for
your tool. When cleaning a tool be careful
not to disassemble any portion of the tool
since internal wires may be misplaced or
pinched or safety guard return springs may
be improperly mounted. Certain cleaning
agents such as gasoline, carbon tetrachloride,
ammonia, etc. may damage plastic parts.
Risk of injury to user. The power cord must
only be serviced by a Bosch Factory Service
Center or Autho rized Bosch Service Station.
Safety Rules for Jig Saws

Additional Safety Warnings

f. Keep hands away from cutting area.
Do not reach under the material being
cut. The proximity of the blade to your
hand is hidden from your sight.
g. Keep hands from between the gear
housing and saw blade holder. The
reciprocating blade holder can pinch
your fingers.
h. Do not use dull or damaged blades.
Bent blade can break easily or cause
kickback.
i. Before starting to cut, turn tool "ON"
and allow the blade to come to full
speed. Tool can chatter or vibrate if
blade speed is too slow at beginning of
cut and possibly kickback.
j. Always wear safety goggles or eye
protection when using this tool. Use a
dust mask
applications which generate dust.
k. Secure material before cutting. Never
hold it in your hand or across legs.
Small or thin material may flex or vibrate
with the blade, causing loss of control.
l. Make certain all adjusting screws and
the blade holder are tight before
making a cut. Loose adjusting screws
and holders can cause the tool or blade
to slip and loss of control may result.
grinding, drilling, and other construction
activities contains chemicals known to cause
cancer, birth defects or other reproductive
harm. Some examples of these chemicals
are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement
and other masonry products, and
• Arsenic and chromium from chemically-
treated lumber.
Your risk from these exposures varies,
depending on how often you do this type of
work. To reduce your exposure to these
chemicals: work in a well ventilated area, and
work with approved safety equipment, such
as those dust masks that are specially
designed to filter out microscopic particles.
-4-
or respirator
Some dust created by
power sanding, sawing,
for