Blue Clean AR 240 S Instrucciones De Montaje, Cuidado Y Uso página 11

OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
Spray
1
1
15ANR011 AR240S_1700PSI ENG-FR-SP.indd 11
Pressure
2
• When removing the detergent tank remove lid and
place finger in tank lifting up while pulling tank out.
Operation Tips
• If you hear the motor run intermittently when the
trigger is not being squeezed, that is normal.
The pump is priming itself so it is ready to operate
when the trigger is squeezed. Turn off the power
washer if not being used after five minutes.
• The o-rings on the bayonet end of the lance should
be cleaned regularly and lubricated with non-water
soluble grease such as petroleum jelly.
• Keep the nozzle cleaning wire for use in unclogging
the nozzle. If you lose the cleaning wire, a
straightened paper clip also works.
How to Avoid Damaging Surfaces
• Damage to surfaces being cleaned occurs
because the impact force of the water pressure
exceeds the durability of the surface. Bare wood
can be penetrated; paint can be peeled off, etc.
You can vary the force of your power washer by
controlling:
1. The angle of the surface being cleaned
2. The distance of the nozzle from the surface
being cleaned
• NEVER use a narrow high pressure stream of
water on soft surfaces susceptible to damage.
• Use the high/low nozzle lance when cleaning
windows. Be sure to adjust the nozzle to low spray
and place the nozzle approximately four to five feet
away from the window with the nozzle at forty five
degree angle. Squeeze the trigger and vary the
spray pattern and angle until optimum cleaning
efficiency is achieved.
11
16/12/17 下午1:43