Toyotomi zibro LC – 320 Instrucciones De Uso página 21

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 62
F
SETTING THE REQUIRED TEMPERATURE
The temperature setting can only be adjusted,
the adjustment keys
keys to switch on the function (the °C mark ¸ will start blinking). Next, adjust the
temperature using the key on the right ( min.) to set the temperature to a higher
setting and the key on the left ( hour) to lo er the temperature. Press once to
increase the value one step. After appro imately 10 seconds the C mark
blinking and the setting
The available temperature settings range from 6 C minimum to 28 C ma imum.
When the heater has been unplugged (or after a power failure), the temperature
will reset to the factory setting of 20°C.
G
SWITCHING OFF THE HEATER
There are two ways to switch off the heater.
1
Press the
button ¹. The information display will show the CLOCK
signal. Within approximately one minute the flame will have extinguished.
2 Press the TIMER key
again with the timer the next time. This not only switches off the heater, but
it also activates the timer function.
H
THE INFORMATION DISPLAY
The information display ¸ not only serves as an indicator of the (set) time and
temperature (Sections C, D, and F), it also indicates any malfunctioning of the
heater. The code on the information display tells you what is the matter:
CODE
INFORMATION
e - 0
Temperature
f - 0
Po er interrupted.
e - 1
aulty thermostat.
f - 1
aulty burner thermistor.
e - 2
Starting problems.
Re-ignite the heater immediately after
e - 23
extinguishing.
e - 5
Tipping-over protection.
e - 6
Poor burning.
e - 7
Room temperature
above 32 C.
e - 8
Defective booster.
e - 8 1
Abnormal fre uency.
e - 9
Air filter dirty or
uel pump dirty.
The heater has been in operation
continuously for a period of 6 hours
and has turned itself off automatically.
Out of fuel.
-- : --
+
Too little ventilation.
-- : --
+
e - 1 1
Too little ventilation.
+
Al ays contact your dealer for any malfunctioning not listed above and/or
the error keeps occuring after taking the corrective measure as described above.
to adjust the temperature. irst press either of the t o
ill be locked ( ig.
).
, when you want to switch off the heater and ignite it
ithin the heater too high.
hen the heater is burning. Use
WHAT TO DO
Cool-do n and re-ignite.
Re-ignite the heater.
Contact your dealer.
Contact your dealer.
Contact your dealer.
Wait for appro . 30 sec.
and re-ignite after inserting
the plug again.
Re-ignite the heater.
Contact your dealer.
If necessary,
re-ignite the heater.
Contact your dealer.
Insert the plug into the
Contact your dealer.
Clean filter.
Contact your dealer.
S itch the heater back on.
Refill removable tank.
Ventilate better.
Ventilate better.
ill stop
In case of any
malfunctioning the
information display will
tell you what is the
matter.
all-socket again.
hen
4
9

Publicidad

Tabla de contenido
loading

Tabla de contenido