Descargar Imprimir esta página

Toyotomi zibro LC – 320 Instrucciones De Uso página 23

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 62
M
MAINTENANCE
S itch off the heater and let it cool do n, before you start any maintenance
ork. Also disconnect the plug from the mains. Your heater needs hardly any
maintenance. It is, however, important that you clean the vent filter
vacuum cleaner and the grid
Regularly inspect the fuel filter as well:
1 Remove the removable tank
( ig. M). Some drops may leak from the filter keep a cloth at hand.
2 Remove the dirt by tapping the fuel filter upside-do n against a hard surface.
(Never clean it with water!)
3 Reinstall the fuel filter into the heater.
We recommend that you remove dust and stains from time to time with a damp
cloth, because otherwise these may cause stains that are hard to remove.
!
Do not remove any heater components yourself. Al ays contact your dealer
for repairs. When the power cord is damaged, it may only be replaced by an
authorised fitter. Use a ne
N
STORAGE (END OF THE HEATING SEASON)
At the end of the heating season, you must store the heater in a dust-free place, if
possible in its original packaging. Unused fuel cannot be used in the ne t heating
season. We therefore recommend that you burn up all fuel. If there is still some
fuel left, do not throw it away, but dispose of it in accordance with the local
regulations for the disposal of domestic chemical waste.
Al ays start the ne
heater follow the instructions again (starting from Section A and as specified).
O
TRANSPORTATION
Take the following measures to avoid fuel leakage during the transportation of
the heater:
1 Let the heater cool down.
2 Remove the removable tank
(refer to Section M, Fig. M). Some drops may leak from the filter keep a cloth
at hand. Store the fuel filter and the removable tank outside the heater.
3 Place the transportation cap into the position of the fuel filter ( ig. N).
Press it tight. The transportation cap
leakage from the heater during transport.
4 Al ays move the heater in an upright position.
5 Make the fixed tank empty with a fuel pump before transportation or in case
of
rong or dirty fuel. irst remove the fuel filter and then insert the fuel
pump into the empty fi ed tank. ollo
contains water.
with a damp cloth, both on a weekly basis.
from the heater and remove the fuel filter
cord of the type H0 VV- .
heating season
ith fresh fuel. When you start re-using the
from the heater and remove the fuel filter
ill, as much as possible, prevent oil
the same procedure if the fuel tank
with a
Transportation
cap
4
11
M
N

Publicidad

loading