Key To Symbols; Symbols On The Machine And/Or In The Manual - Husqvarna 440e II TrioBrake Manual De Instrucciones

Ocultar thumbs Ver también para 440e II TrioBrake:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Symbols on the machine and/or in
the manual:
WARNING! Chain saws can be
dangerous! Careless or improper use
can result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you understand
the instructions before using the
machine.
Always wear:
Approved protective helmet
Approved hearing protection
Protective goggles or a visor
Both of the operator's hands must be
used to operate the chain saw.
Never operate a chain saw holding it with
one hand only.
Contact of the guide bar tip with any
object must be avoided.
Recommended cutting
equipment in this example:
- Bar length 15 inches
- Max. nose radius 10 Teeth
- Husqvarna H30
Other approved bar and chain
combinations in Operator's Manual.
Measured maximum kickback value with
brake for the bar and chain combination
on the label.
Measured maximum kickback value
without triggering the brake, for the bar
and chain combination on the label.
WARNING! Kickback may occur when the
nose or tip of the guide bar touches an
object, and cause a lightning fast reverse
reaction, kicking the guide bar up and
towards the operator. May cause serious
personal injury.
Ignition; choke: Set the choke control in
the choke position. This should
automatically set the stop switch to the
start position.
1155361-49 Rev.3 2017-05-03

KEY TO SYMBOLS

Air purge.
Adjustment of the oil pump.
Refuelling.
Chain oil fill.
Chain brake, activated (right) Chain
brake, not activated (left)
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
Switch off the engine before carrying
out any checks or maintenance.
CAUTION! The start/stop switch
automatically returns to run position. In
order to prevent unintentional starting,
the spark plug cap must be removed
from the spark plug when assembling,
checking and/or performing
maintenance.
Always wear approved protective
gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be
worn.
Refuelling.
Filling with oil and adjusting oil flow.
English
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

445e ii triobrake

Tabla de contenido