Key To Symbols; Symbols On The Machine; Symbols In The Operator's Manual - Husqvarna 435 II Manual De Instrucciones

Symbols on the machine:

WARNING! Chain saws can be
dangerous! Careless or incorrect use
can result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
This product is in accordance with
applicable EC directives.
Noise emission to the environment
according to the European
Community's Directive. The machine's
emission is specified in the Technical
data chapter and on the label.
Ignition; choke: Set the choke control
in the choke position. This should
automatically set the stop switch to the
start position.
Refuelling.
Chain oil fill.
Air purge
Adjustment of the oil pump
Chain brake, activated (right) Chain
brake, not activated (left)
Other symbols/decals on the machine refer to special
certification requirements for certain markets.
1158413-39 Rev.1 2016-09-05

KEY TO SYMBOLS

Symbols in the operator's
manual:
Switch off the engine before carrying
out any checks or maintenance.
CAUTION! The start/stop switch
automatically returns to run position.
In order to prevent unintentional
starting, the spark plug cap must be
removed from the spark plug when
assembling, checking and/or
performing maintenance.
Always wear approved protective gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be
worn.
Refuelling.
Filling with oil and adjusting oil flow.
The chain brake must be engaged when
the chain saw is started.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches
an object, and cause a lightning fast
reverse reaction, kicking the guide bar
up and towards the operator. May cause
serious personal injury.
–
English 7