Kohler K-168 Guia De Instalacion página 4

Faucet Base
Round Base
Spray Inlet
Fiber
Washer
2. Install the Faucet
NOTE: A rubber washer is located in the depression in the round
base.
Slip the round base over the tubing and to the faucet base.
Fit the faucet through the sink hole.
Position the faucet so the spray inlet is toward the back.
Partially thread the screws into the ring until they barely protrude
from the backside of the ring.
Slide the fiber washer and metal washer on the threaded shank.
Thread the ring to the threaded shank until it is about 1/4 turn
from touching the sink bottom.
Turn the ring so the screws are to the front and back of the
faucet.
Tighten the screws using a Phillips screwdriver.
1015073-2-E
Threaded Shank
Tubing
Metal Washer
Ring
Screws
4 Kohler Co.