ClosetMaid 2894 Instrucciones De Instalación

Descargar este manual

Organizador de Despensa de 1,22 m

Before You Begin

1. Remove product from packaging and carefully inspect all

parts. (See Parts List below.)

2. Please read all instructions carefully before beginning.

Antes de empezar

1. Remueva el producto del paquete y cuidadosamente

inspeccione todas las partes. (Vea la lista de partes

abajo).

2. Haga el favor de leer todas las instrucciones

cuidadosamente antes de empezar.

4' Pantry Organizer

Installation Instructions

Instrucciones de Instalación

Parts List

a. Close Mesh 4' Shelves (4) 02-4318

b. 48" Standards (3) 01-28044

c. Shelf Brackets (12) 02-42854

d. 40" Hang Track (1) 01-28266

e. Shelf End Caps (32) 01-603

f. 3/16" Toggle Bolts (8) 01-270/ 01-274

g. #12 x 2" Pan Head Screws (8) 01-688

h. 1/4" Anchors (8) 01-650

Lista de Partes

Repisas de Close Mesh de 1,22 cm

(4) 02-4318

b. Rieles Verticales de 1,22 m (3) 01-28044

c. Soportes de Repisa (12) 02-42854

d. Riel Horizontal de 1 m (1) 01-28266

e. Tapones para Repisa (32) 01-603

f. Pernos de Palanca de 4,7 mm (8) 01-270/01-274

g. Tornillos de Cabeza Redonda #12 x 5 cm

(8) 01-688

h. Tarugos de 6 mm (8) 01-650

#2894

4' (1,22 m)

Página 1 #2894 4' (1,22 m) 4' Pantry Organizer Installation Instructions Organizador de Despensa de 1,22 m Instrucciones de Instalación Before You Begin 1. Remove product from packaging and carefully inspect all parts. (See Parts List below.) 2. Please read all instructions carefully before beginning.
Página 2 Tools and Materials Herramientas y materiales 1/4" (6 mm) Measure and Fit NOTE: This oganizer requires a minimum wall area or pantry width of 4'. It can also easily be installed on a wall area or a pantry wider than 4'. However, in the case of a wall area or pantry which is smaller than 4', the Hang Track and/or the Shelves will require cutting.
Página 3 Install Hang Track DRYWALL MURO SECO To install Hang Track into drywall: IMPORTANT: For 1. Drill 1/2" holes at marked locations on wall. optimum performance, 2. Remove toggle from bolt. Insert bolt through hole in Hang Track and re-install toggle onto end of bolt. align holes 1, 3, and 5 3.
Página 4 1-800-874-0008 (U.S.A and Canada) with manufacturer's instructions, it will be www.closetmaid.com exchanged free of charge. Only the unsatisfactory part in a multi-piece product will be exchanged. © ClosetMaid Corporation 2002 Manufacturer reserves the right to change 01-84715 Printed in U.S.A. specifications without notice.