Publicidad
Enlaces rápidos
a
b
i
h
j
m
NOTE: Hardware included for installation into drywall or plaster 1/2" to 5/8" thick. Other wall
types require additional hardware. See "Wall Types" section to determine hardware needs.
NOTA: Se incluyen herrajes de instalación para muro seco o yeso de 1,2 cm a 1,5 cm. Otros
tipos de paredes requieren herrajes de instalación adicionales. Vea la sección "Tipos de
Paredes" para determinar qué tipo de herrajes necesita.
d
c
f
k
n
®
Before You Begin
1. Remove product from packaging and carefully inspect all
parts. (See Parts List below.)
2. Please read all instructions carefully before beginning.
Antes de Empezar
1. Saque el producto del paquete y cuidadosamente
inspeccione todas las piezas. (Vea la lista de piezas a
continuación.)
2. Lea todas las instrucciones cuidadosamente antes de empezar.
Parts List
e
a. Wardrobe shelves—long (3) 02-4300
b. Storage shelves—short (2) 02-45640
c. Support pole (4) 01-699
d. Shelf end caps (48) 01-603/604
e. Wall clip (28) 01-40911
f. Side wall bracket (3) 01-40984
g. Pole end cap (4) 01-244
g
h. 1/2" phillips head screw (12) 01-215
i. Pole clips (12) 01-40977
j. Pole connector (2) 01-4307
k. 1" pins (28) 01-658
l. Shoe support bracket (2) 01-40923
m. Shoe shelf (1) 02-45640
l
n. Pre-loaded anchor (6) 01-50955
Lista de Piezas
a. Repisas colgadoras—largas (3) 02-4300
b. Repisas de almacenaje—cortas (2) 02-45640
c. Postes de soporte (4) 01-699
d. Tapones para repisa (48) 01-603/604
e. Fijadores de pared (28) 01-40911
f. Soportes laterales (3) 01-40984
g. Tapones de poste (4) 01-244
h. Tornillos de cabeza phillips, 1,2 cm (12) 01-215
i. Fijadores de poste (12) 01-40977
j. Conectores de poste (2) 01-4307
k. Clavijas de 2,5 cm (28) 01-658
l. Soporte para repisa para zapatos (2) 01-40923
m. Repisa para zapatos (1) 02-45640
n. Tarugos precargados (6) 01-50955
5' - 8' (1,52 - 2,44 m)
Closet Organizer
Installation Instructions
Organizador de Clóset
Instrucciones de Instalación
Tools and Materials
Herramientas y Materiales
1/4" (6 mm)
Phillips Head
De cabeza Phillips
#1608
TM
Publicidad
Manuales relacionados para ClosetMaid 1608
Resumen de contenidos para ClosetMaid 1608
- Página 1 #1608 ® 5' - 8' (1,52 - 2,44 m) Closet Organizer Installation Instructions Organizador de Clóset Instrucciones de Instalación Tools and Materials Herramientas y Materiales 1/4" (6 mm) Phillips Head De cabeza Phillips Before You Begin 1. Remove product from packaging and carefully inspect all parts.
- Página 2 Prepare Hardware 1. Determine top of each pole by locating hole closest to end. 2. Attach an endcap to top of one pole and bottom of other Bottom pole. Repeat for second set of poles. Parte Parte 3. Attach pole clips to each set of poles with 1/2" screws superior inferior (provided) as shown.
- Página 3 Measure and Fit This closet organizer is designed to fit a maximum opening of 8 feet. No cutting or adjustments are necessary for closets 8 feet wide (skip to steps 3-4 and follow measuring diagrams Do not cut here! below). For closets less than 8 feet wide, the Wardrobe (long) ¡No corte aquí! shelves can extend past pole or be cut to size.
- Página 4 Wall Types Wall type will determine installation requirements for wall clips. Please read the following instructions carefully. 1. Drywall and Plaster— Pins are required for installation in standard drywall (most drywall is 1/2" to 5/8" thick). Drill 1/4” holes into wall and use supplied pins. If drywall or plaster is more than 5/8" thick, drill 1/4"...
- Página 5 Install Shelves (Cont.) 4. Replace sidewall bracket on front lip of shelf and raise to align with holes. Place preloaded anchor through bracket and into holes in wall. Use bottom of hammer handle to push in pins. To remove, pry pins out with screwdriver. 5.
- Página 6 Baje la parte delantera de la repisa hasta que el soporte para zapatos quede en la pared trasera. Repita los pasos para el otro soporte para zapatos. If a ClosetMaid ® product does not...