Assembly - Husqvarna TS 142 Manual De Operario

Keys
(2) Keys
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Stan dard
wrench sizes are listed.
(1) 5/16" wrench
(2) 7/16" wrenches
(2) 1/2" wrenches
(1) 9/16" wrench
When right or left hand is mentioned in this man ual, it means
when you are in the operating po si tion (seated be hind the
steer ing wheel).
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
• Remove all accessible loose parts and parts cartons
from carton.
• Remove end panels and lay side panels fl at.
• Check for any additional loose parts or cartons and
remove.
BEFORE REMOVING TRACTOR FROM
SKID
CONNECT BATTERY (See Fig. 1)
WARNING: Do not short battery ter mi nals
by allowing a wrench or any other object
to contact both terminals at the same
time. Before connecting battery, remove
metal bracelets, wristwatch bands, rings,
etc. Positive terminal must be connected
fi rst to prevent sparking from ac ci den tal
grounding.
NOTE: If this battery is put into service after month and
year indicated on label (label is located between terminals)
charge battery for minimum of one hour at 6-10 amps. (See
"BATTERY" in the Maintenance section of this manual for
charging instructions.)
• Determine battery location. Battery location will be
under the seat or the hood.
UNASSEMBLED PARTS
(1) Oil Drain Tube
For Future Use
(1) Quick
Connect

ASSEMBLY

Utility knife
Tire pressure gauge
Pliers
Slope Sheet
• Lift seat pan or hood to raised position.
• Remove two terminal caps and discard.
• First connect RED battery cable to positive (+) terminal
with bolt and nut as shown. Tighten securely. Slide
terminal cover over terminal.
• Connect BLACK grounding cable to negative (-)
ter mi nal with remaining bolt and nut. Tighten se cure ly.
TERMINAL
COVER
POSITIVE
(RED)
CABLE
02605
TO INSTALL STEERING WHEEL (See Fig. 2)
INSTALL STEERING WHEEL
• Slide extension shaft onto lower steering shaft.
• Slide upper steering mount onto extension.
• Orient the steering mount so the base sits fl at on the
upper dash.
• Install four self-tapping screws using a #2 Phillips
screwdriver.
• Hand tighten each screw until fl ush against the steering
mount, then turn an additional 90 degrees.
NOTE: Do not over tighten screws.
• Place tabs of steering boot over tab slots in dash and
push down to secure.
• Position front wheels of the tractor so they are pointing
straight forward.
• Remove steering wheel adapter from steering wheel
and slide adapter onto steer ing shaft ex ten sion.
• Position steering wheel so cross bars are hor i zon tal
(left to right) and slide inside boot and onto adapt er.
5
Battery
(2) Nut Keps
(2) Hex Bolts
*Installed by Dealer
*Brush Guard Kit
NUT
TERMINAL
LABEL
CAP
BOLT
Fig. 1
NEGATIVE
(BLACK)
CABLE