Husqvarna TS 142 Manual De Operario página 6

• Assemble large fl at washer, lock washer, hex bolt and
tighten se cure ly.
• Snap steering wheel insert into center of steer ing wheel.
• Remove protective materials from trac tor hood and
grill.
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN
SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS
TO ROLL OFF SKID.
INSERT
BOLT
LOCK
WASHER
LARGE FLAT
WASHER
SCREWS
LOWER
STEERING
SHAFT
INSTALL SEAT (See Figs. 3 - 5)
• Remove bolts and winged washers se cur ing seat to
cardboard packing and set aside for as sem bly of seat
to tractor. Remove the cardboard packing and discard.
IMPORTANT: Do not remove tape from adjustment handle
until seat is properly secured to tractor.
• Connect wiring harness to the seat switch.
MIDDLE PAD
SEAT
SWITCH
FRONT PAD
FRONT SLOT
SEAT PAN
ASSEMBLY
STEERING
WHEEL
STEERING
BOOT
ADAPTER
EXTENSION SHAFT
STEERING MOUNT
Fig. 2
TAPE
WIRING HARNESS
MIDDLE SLOT
Fig. 3
NOTE: All three pads will not install at the same time. The
middle pad must be installed fi rst before other pads will
align with assembly holes.
• Place seat on seat pan so middle pad is aligned with
middle slot assembly hole.
• Insert pad and pull seat towards rear of tractor until
front two pads align with front slot assembly holes
• Insert pads by providing evenly distributed light down-
ward pressure and pull seat towards rear of tractor,
making sure front pads are engaged on the seat pan.
• Raise seat. Assemble bolts and winged washers and
tighten securely to front pads.
NOTE: Ensure "UP" reads right side up and arrow is point-
ing up on winged washers as shown.
SLOT
PAD
WINGED
WASHER
BOLTS
WINGED WASHER
• Remove tape and discard.
WARNING: Ensure the seat assembly is securely
fastened to the seat pan before occupying or operating
tractor.
• Lower seat into operating position and sit on seat.
Press clutch/brake pedal all the way down. If operating
position is not comfortable, adjust seat.
TO ADJUST SEAT (See Fig. 5)
• Grasp adjustment handle and pull up. Slide seat to
desired position and release adjustment handle.
IMPORTANT: Before operating tractor, ensure operator
presence switch is functioning properly (see "CHECK
OPERATOR PRESENCE SYSTEM" in the MAINTENANCE
section of this manual).
6
Fig. 4
TAPE
ADJUSTMENT
HANDLE
SEAT PAN
Fig. 5