Naterial NORI 2 LED Instrucciones De Montaje, Utilización Y Mantenimiento página 92

Step 4: 1. Find «P2» button in the battery slo rstly 2. Keep ear near to the head of motor under
quite environment and then press «P2» button 2 times successively. At the same time you will
FR
hear «Di-Di», small and more shorter.
ES
Step 5: After the sound of «Di-Di», press «Open» button for 3 seconds and then release, you will
hear successive short sound of «Di-Di---» at the same time when you press the «open» button.
PT That means motor-coding works
Step 6: 1. Check whether motor is working. 2. If motor is on the work, press «close» button for
IT
3 seconds. If motor turns in the contrary direction as when opening «open» button. It means
motor can work normally. (If motor refuse to turn, then it needs to adjust its limit. (See Method
EL
for adjusting motor limit)).
PL
8. WARNING
UA
Attention: Wel
RO
adjust the motor again.
The user can adjust the limit of one direction at one time, do not adjust two knobs at the same
EN
time.
Do not turn k
cycle, and check if the setting you sa
WARNING
The replacement and installation of batteries must be done by an adult.
Remove the worn out batteries of this product.
Do not expose the batteries t re, they may leak or explode.
Do not short-circuit the battery terminals.
Do not mix old batteries with new ones.
Do not use rechargeable batteries in this product.
Do not recharge batteries that are not rechargeable.
Use only the recommended type of batteries.
Keep this product away from the reach of children.
The drive shall be disconnected from its power source during cleaning, maintenance and
when replacing parts.
WARNING: the drive shall be disconnected from its power source during cleaning,
maintenance and when replacing parts.
Maintenance
Check to make sure that the awnin
tting program already for all electric it
rcely, please check the limit with remote control per revolute about half
xed tightly and securely before cleaning.
92
al client no need