Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
• To prolong the original appearance, clean with clear water and a soft damp cloth only.
• Do not use paints, solvents, or other chemicals on this light fixture. They could cause
a premature deterioration of the finish. This is not a defect in the finish and will not be
covered by the warranty.
• Do not spray with hose or power washer.
SYMPTOM
POSSIBLE CAUSE
Light will not
1. Light switch is turned off.
come on.
2. Bulb is loose or burned out.
3. Fuse is blown or circuit
4. Daylight turn-off is in ef-
5. Incorrect circuit wiring, if
Light comes
1. Light control may be in-
on in daylight.
2. Light control is in Test
Light comes
1. Light control may be
on for no
apparent
reason.
Please call 1-800-858-8501 (English speaking only) for assistance before returning
If you experience a problem, follow this guide. You may also want to visit our Web site at:
www.hzsupport.com. If the problem persists, call* for assistance at 1-800-858-8501 (English
speaking only), 8:00 AM to 5:00 PM CST (M-F). You may also write* to:
HeathCo LLC
P.O. Box 90045
Bowling Green, KY 42102-9045
ATTN: Technical Service
* If contacting Technical Service, please have the following information available: Model
Number, Date of Purchase, and Place of Purchase.
Please keep your dated sales receipt, it is required for all warranty requests.
204093-03
CARE AND MAINTENANCE
TROUBLESHOOTING GUIDE
breaker is turned off.
fect (recheck after dark).
this is a new installation.
stalled in a relatively dark
location.
(Set control switch to an
ON-TIME position).
sensing small animals or
automobile traffic (Reduce
sensitivity).
TECHNICAL SERVICE
No Service Parts Available for this Product
SYMPTOM
Light stays
on continu-
ously.
Light flashes
on and off.
product to store.
7
POSSIBLE CAUSE
1. The sensor is pointed toward
a heat source like an air
vent, dryer vent, or brightly
painted, heat reflective
surface (Reduce sensitivity).
2. Light control is in Manual
Mode. (Switch to Auto.)
3. Light control is in
D
B
mode.
®
ual
rite
4. Sensitivity is set too high.
(Reduce sensitivity.)
1. Light control is in the Test
mode and warming up
(Flashing is normal under
these conditions).
2. Heat being reflected from
other objects may be
affecting the sensor. (Re-
aim sensor.)
Publicidad
Tabla de contenido
