Battery Replacement; Care And Cleaning - Heath Zenith SECUR360 9304 Manual Del Usuario

BATTERY REPLACEMENT

IMPORTANT: Properly dispose of drained batteries.
1. Press the bottom tab of the wall mounting plate and
slide the light fixture up and off of the mounting plate.
2. Remove the battery cover on the back of the light
fixture and remove the old batteries.
3. Install four new 1.5V "D" batteries into the battery
compartment. Make sure the polarity of the batteries
is correct.
4. Replace the battery cover.
5. Place the top rear of the light fixture over the wall
mounting plate and slide the fixture down onto the
wall mounting plate. Slide the light fixture down until
the bottom tab clicks and locks the light fixture into
place.
• To prolong the original appearance, clean the light fixture with clear water and a soft, damp cloth only.
• Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature deterioration of the
finish. This is not a defect in the finish and will not be covered by the warranty.
• Do not spray the light fixture with a hose or power washer.
• If not to be used for several weeks, turn the unit OFF.
Motion Sensing Range .........................Up to 40 ft. (12 m) [Varies with surrounding temperature].
Motion Sensing Angle .........................Up to 180°
Power Requirements ............................."D" Alkaline Batteries (4x) (not included)
Offline Operating Modes .....................TEST, OFF, and MOTION ACTIVATED
ON-Timer ............................................20 seconds (non-adjustable) (Night Only)
Test Timer ............................................5 Seconds (Day and Night)
Sensitivity (SENS) ..............................."L", "M", "H"
LED Lumens .......................................650
LED color temperature ........................4700K
6

CARE AND CLEANING

SPECIFICATIONS
To see operational and troubleshooting information and videos,
go to www.hzsupport.com
"D" Batteries
Battery Cover
210449-01
E N
O P S E
C L O
T O
E S S
P R