Rear Panel - Omnitronic CMP-101 Manual Del Usuario

15./16. REV/FWD BUTTONS
Pause-mode:
To cue and reverse at a very low speed. You can exactly select the starting-point or cue point. The selected
frame is repeated until you press the Play-button.
Playback-mode:
Use the Search/Scan buttons in order to cue and reverse at a very high speed.
17. PITCH-BUTTON
With this button, you can switch the speed adjustment via the Pitch control on and off. Please refer to 6.6
Adjusting the playback speed.
18. HEADPHONES SOCKET
Use this socket to connect the headphones. Headphones from 8 Ohms to 600 ohm can be used.
19. INFRARED SENSOR
For receiving signals of the optional remote control.
20. DISPLAY
LC display for displaying the different modes and functions. Please refer to the explanations under 6.3 LC
display.

4.3 Rear panel

21. AUDIO OUT-SOCKETS
The music signal of these sockets is analog. Connect the output to the respective input of your mixer.
22. AC CONNECTION
Plug in the power supply cable here.
00030404.DOC, Version 1.0
18/43