GYS Easymig 160 Manual Del Usuario página 13

MADE IN FRANCE
Stay away from moving parts (e.g. engine, fan...) with hands, hair, clothes etc...
Never remove the safety covers from the cooling unit when the machine is plugged in - The
manufacturer is not responsible for any accident or injury that happens as a result of not
following these safety precautions.
The pieces that have just been welded are hot and may cause burns when manipulated.
During maintenance work on the torch or the electrode holder, you should make sure it's cold
enough and wait at least 10 minutes before any intervention. The cooling unit must be on
when using a water cooled torch in order to ensure that the liquid does not cause any burns.
ALWAYS ensure the working area is left as safe and secure as possible to prevent damage or
accidents.
WELDING FUMES AND GAS
The fumes, gases and dust produced during welding are hazardous. It is mandatory to
ensure adequate ventilation and/or extraction to keep fumes and gases away from the work
area. An air fed helmet is recommended in cases of insufficient air supply in the workplace.
Check that the air intake is in compliance with safety standards.
Care must be taken when welding in small areas, and the operator will need supervision from a safe distance.
Welding certain pieces of metal containing lead, cadmium, zinc, mercury or beryllium can be extremely toxic. The
user will also need to degrease the workpiece before welding.
Gas cylinders must be stored in an open or ventilated area. The cylinders must be in a vertical position secured
to a support or trolley.
Do not weld in areas where grease or paint are stored.
FIRE AND EXPLOSIONS RISKS
Protect the entire welding area. Compressed gas containers and other inflammable material
must be moved to a minimum safe distance of 11 meters.
A fire extinguisher must be readily available.
Be careful of spatter and sparks, even through cracks. It can be the source of a fire or an explosion.
Keep people, flammable objects and containers under pressure at a safe distance.
Welding of sealed containers or closed pipes should not be undertaken, and if opened, the operator must remove
any inflammable or explosive materials (oil, petrol, gas...).
Grinding operations should not be directed towards the device itself, the power supply or any flammable materials.
GAS BOTTLE
Gas leaking from the cylinder can lead to suffocation if present in high concentrations around
the work area.
Transport must be done safely: Cylinders closed and product off. Always keep cylinders in an
upright position securely chained to a fixed support or trolley.
Close the bottle after any welding operation. Be wary of temperature changes or exposure
to sunlight.
Cylinders should be located away from areas where they may be struck or subjected to
physical damage.
Always keep gas bottles at a safe distance from arc welding or cutting operations, and any
source of heat, sparks or flames.
Be careful when opening the valve on the gas bottle, it is necessary to remove the tip of the
valve and make sure the gas meets your welding requirements.
EASYMIG 160 / 160 XL /180-4XL
EN
13