Power Supply Installation; Lock Release Installation - golmar 2PLUS Serie Manual De Instalación

60
I
nstalling the FA-PLUS/C ver. 938072 power supply.
3,5 x 45
DIN-7971
The power supply can be installed on a DIN 46277 guide
by simply pressing it. To disassemble the power supply,
use a plain screwdriver to lever it, as it is shown on the
picture.
The FA-PLUS/C power supply uses 6 units over DIN guide.
Place the protection cover once the input terminals are wired.
L
ock release installation.
If the lock release is installed in a metal door, use a
drill and tap the hole.
In case of wood door, use a
IMPORTANT: the lock release must be of 12V a.c. or d.c (see pages 67 to 70).

POWER SUPPLY INSTALLATION

The power supply must be installed in a dry and
3,5 x 45
protected place. Remember the current regulation
DIN-7971
forces you to protect the power supply with a
magnetocaloric switch.
To install the power supply on the wall, drill two holes of
and insert the wall plugs. Hold the power supply by means of
the specified screws.

LOCK RELEASE INSTALLATION

Ø 3 mm drill.
DIN 46277
3,5 x 25
DIN-7972
Ø3,5mm
M 4 x 8
DIN-963
Ø 6mm