Power Supply Installation; Lock Release Installation - golmar Rock Serie Manual De Instalación

66
F
inal adjustments
If, when using the device, audio volume is inadequate, it is necessary to carry out
some adjustments, as shown in the picture.
The camera is equipped with an horizontal and vertical orientation device.
If orientation is not correct, change it.
Fix the doorpanel to the embedding box by means of the proper screws.
D
etail of FA-805 power supply installation.
3,5 x 45
DIN-7971
The power supply can be installed on a DIN 46277
guide rail (6 elements) pushing it slightly.
To remove the power supply from the guide rail,
put a flat screwdriver under the edge and
prise it open as shown in the picture.
D
etail of the lock release installation.
If the lock release must be installed on a metal door,
use a 3,5mm drill and thread the hole.
If it must be installed on a wooden door,
use a 3mm drill.
WARNING: See connection diagra
DOOR PANEL INSTALLATION

POWER SUPPLY INSTALLATION

Install the power supply in a dry sheltered place.
Remember that, according to the regulations in force,
it is necessary to protect the power supply by means of
3,5 x 45
DIN-7971
a magnetothermic switch.
To install the power supply in the wall, drill two holes whose diameter
is 6mm and insert the plugs. Fix the power supply by means of
the proper screws.

LOCK RELEASE INSTALLATION

ms on page 80.
DIN 46277
3,5 x 25
DIN-7972
M 4 x 8
DIN-963