Hart HPSV50 Manual Del Operador página 6

OPERATION
To remove:
 Switch off unit and remove the battery pack.
 Depress locking tab and pull to remove.
ATTACHING AND REMOVING THE EXTENSION
WAND AND ACCESSORY TOOLS
See Figure 6, page 9
The extension wand and accessory tools can be used
together or separately for a variety of cleaning tasks.
To connect:
 Switch off unit and remove the battery pack.
 For the extension wand, align the pins on the extension
wand with the receptacle in the stick vacuum.
 Press together until it clicks into place.
 For accessory tools, insert the tool into the outlet of the
stick vacuum or the extension wand.
 Press together until it clicks into place.
 Replace battery pack.
To remove:
 Switch off unit and remove the battery pack.
 Depress locking tab and pull to remove.
EMPTYING/REMOVING/REATTACHING THE
DUST BOWL
See Figures 7 - 10, pages 9 - 10.
The dust bowl should be checked, emptied, and cleaned
periodically for maximum dust collection.
To empty:
 Remove the battery pack.
 Hold unit over waste receptacle.
 Press lock tab on bottom of bowl to release spring loaded
door.
 Shake lightly or tap sides to dislodge debris.
 Close door, pressing firmly until lock button engages.
To remove:
 Remove the battery pack.
 Push the release button located on top of the hand vac.
Rotate and pull the dust bowl down and out.
To reattach:
 Position the two sections as shown. Align the slot on the
bottom of dust bowl with the tab on the bottom of motor
housing, then rotate and snap the two sections together.
REMOVING BLOCKAGES AND CLEANING THE
ROLLER BAR
See Figure 11, page 10.
Obstructions in the roller bar may activate the overload
protection sensor and must be removed. The roller bar will
stop and the light on the roller bar will illuminate red.
To reset:
 Remove the battery pack.
 Remove the roller bar assembly from the wand or stick
vacuum base and clear any obstructions with a blunt
object.
NOTE: Use scissors to remove any threads or hair
wrapped around the roller bar.
 Wait at least 1 minute before reattaching the assembly.
For use with HPBB01 or HPBB50 Roller Bar
6 – English