Connect Electrical Supply; Combination With Combi-Steam Oven - Gaggenau BO 450 611 Instrucciones De Instalación

For this purpose, slightly pull out the appliance from the
built-in cut-out. At the top of the appliance there is an
oval opening located on the hinge side. Slightly loosen
both screws (Inbus 5 mm), but do not remove them!
Align the door via the lateral screw (Torx 20).
Tighten both screws (Inbus 5 mm) again.
Notes
‒ The alignment of the appliance door can be
adjusted via the upper hinge, in order to achieve a
precise gap size of the top edge of the door to the
upper air output.
‒ The height of the door cannot be adjusted.
‒ The device door is already aligned when the
appliance is delivered. You do not normally need to
align the door.

Connect Electrical Supply

Three wire connection
BO 450/451-611
1 Connect red wire from oven to red electrical supply
wire (hot wire).
2 Connect black wire from oven to black electrical
supply wire (hot wire).
3 Connect yellow/green ground oven wire to bare
ground electrical supply wire.
Attach flexible conduit to the junction box.
To facilitate serviceability, the flex conduit must not be
shortened and should be routed to allow for temporary
removal of the oven.
Four wire connection
BO 480/481-611
1 Connect red wire from oven to red electrical supply
wire (hot wire).
2 Connect black wire from oven to black electrical
supply wire (hot wire).
3 Connect white wire from oven to white electrical
supply wire (neutral).
4 Connect yellow/green ground oven wire to
electrical supply ground wire.
Attach flexible conduit to the junction box.
To facilitate serviceability, the flex conduit must not be
shortened and should be routed to allow for temporary
removal of the oven.

Combination with combi-steam oven

Fit the combi-steam oven first. Pay attention to the
combi-steam oven's installation instructions.
For an installation depth of 550 mm (approx. 1.8 ft),
position the water hoses and the connecting cable in
the area of the housing cut-out.
9