Install Appliance; Mount To Cabinet; Check The Installation; Electrical Installation - Gaggenau EB 333 610 Instrucciones De Instalación

Install Appliance

Note: The appliance is heavy. It is advisable to install it
with a second person.
NOTICE: Before installing the appliance, be sure to
verify the cabinet dimensions and electrical
connections.

Mount to Cabinet

1 Push the appliance fully into the cabinet recess.
Do not kink or trap the connecting cable, or route it
over sharp edges.
2 Remove the transportation lock from the door.
Centre the appliance.
There must be an air gap of
the appliance and adjacent cabinets.
3 Using a spirit level, adjust the appliance so that it is
perfectly level.
4 Secure the appliance at the top on both sides using
into the two screws provided.

Electrical Installation

1 Connect red wire from oven to red electrical supply
wire (hot wire).
2 Connect black wire from oven to black electrical
supply wire (hot wire).
3 Connect white wire from oven to white electrical
supply wire (neutral).
4 Connect yellow/green ground oven wire to
electrical supply ground wire.
Attach flexible conduit to the junction box.
To facilitate serviceability, the flex conduit must not be
shortened and should be routed to allow for temporary
removal of the oven.
/ " (5 mm) between
3
16

Check the Installation

9
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the
OFF position.
Switch on the circuit breaker.
Verify that elements function properly.
Removal
1 Disconnect the appliance from the power supply.
2 Undo the fastening screws.
3 Raise the appliance slightly and pull it out
completely.
7