Hama EWS-870 Instrucciones De Uso página 5

6. Operation
Note – Input
Hold down the CH+ button (10) or the MEM–
button (14) to select the values faster.
6.1. Connection to the measuring station
• After you insert the batteries, the base station
automatically searches for a connection to the
measuring station and performs initial setup.
Note – Input
• Initial setup takes approx. 5 minutes.
• During connection, the wireless symbol on the
measuring station will flash (5).
• Do not press any buttons during setup.
Otherwise, values may not be transmitted
correctly and there is a risk of value errors and
inaccuracies.
• The setup process is completed when the
indoor (7) and outdoor (6) measurement data
is displayed.
• If the base station still does not receive a signal
from the measuring station, press the SENSOR
button (12) to start the manual search for the
signal. During the connection attempt, the
measuring station radio symbol (5) will flash.
• During the manual search, press and hold the
SENSOR button (12) for approx. 3 seconds to end
the search. The radio symbol (4) disappears.
6.2. Selecting the channel/other measuring
stations
Note
You can install two more measuring stations in
addition to the included measuring station. Ensure
that the base and measuring stations are set to the
same channel. Visit www.hama.com for suitable
measuring stations.
• Press the CH+ button (10) repeatedly to set the
channel to that set on the respective measuring
station – see 4.1. Measuring station. Either
1, 2 or 3 (2) is displayed.
• The base station now shows the data measured (6)
on the selected measuring station (2).
4
• Press and hold the CH+ button (10) to select the
channel scan. The measurement values of the
individual measuring stations/channels (2) are
displayed consecutively for 4 seconds each.
• Press the CH+ button (10) again to return to
normal mode.
6.3. Basic and manual settings
Automatic setting using the DCF signal
After the first time the base station is switched on
and successful transmission is established between
the base station and the measuring station, the clock
will automatically search for a DCF signal. During the
search, the wireless symbol (7) will flash.
When the radio signal is received, the date and time
are automatically set.
Radio icon
Anzeige
Funksymbol
Flashing display
Constant display
No display
Signal strength
No reception
Poor
Fair
Excellent
Searching for the DCF
signal
Active
Successful – signal is being
received
Error – signal search ended