Dyna-Glo DGF510SBP Manual Del Usario página 13

ASSEMBLY INSTRUCTIONS
13. Disassemble two M4x10 bolts that are pre-
assembled on the side burner (L) and use them
to assemble the side burner (L) on the right
side burner body (M).
Please ensure the gas valve orifice is correctly
positioned inside side burner inlet (venturi).
14. Connect the side burner sparker wire to the
side burner sparker.
WARNING: IT IS VERY IMPORTANT TO CHECK
AND ENSURE THAT EACH AND EVERY BURNER
IS FULLY ENGAGED WITH THE ADJACENT VALVE
ORIFICE BEFORE COMPLETING STEP 15.
FAILURE TO DO SO MAY RESULT IN FIRE OR
EXPLOSION, POSSIBLY CAUSING SERIOUS
INJURY OR DEATH. REFER TO MAINTENANCE
SECTION INSTRUCTIONS TO PROPERLY CHECK
THE ENGAGEMENT.
Wrong
Correct
Incorrect
Incorrect
Wrong
13
14
Correct
13
M
L
2 Bolts previously
disassembled