Assembly Instructions - Dyna-Glo DGF510SBP Manual Del Usario

ASSEMBLY INSTRUCTIONS

1. Put two leg end caps (P) under left leg
assembly (O), and fasten them with two
ST4.8X10 screws (AA).
Hardware Used
AA
ST4.8x10 Screw
2. Slide the axle (X) through the right leg
assembly (V) and then put the wheels (Y) on
both sides, and tighten the wheels with M10
nuts (BB) with wrenches (CC). Please note, this
step requires two people to complete, and if
necessary any other plier or adjustable wrench
can be used for assembly.
Hardware Used
BB
M10 Nut
M10-M6
CC
Wrench
1
P
x 2
2
V
x 2
x 2
7
O
AA
BB
X
Y