Hansgrohe Axor Citterio 39451001 Instrucciones De Instalación/Garantía página 4


1
4
3
4
English
Installation
Turn the water off at the main
before beginning!
Cut the plaster shield so that it extends ⅜" above the
surface of the finished floor.
Remove the flush housing screws using an 8 mm �llen
wrench (not included).
Remove the flush housing.
Do not discard the screws!
Place the tub filler on the rough (1).
Pivot the tub filler so that it faces the correct direction
().
Make sure that the tub filler is level (3).
Install the screws. Tighten them using an 8 mm �llen
wrench (4).